Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
- 10. Transmissions and power shafts
   - 10.1. Mechanical transmission
      10.1.1. Technical characteristics
      10.1.2. Oil replacement in a transmission
      10.1.3. Removal and installation of the lever of gear shifting
      10.1.4. Removal and installation of a cable of blocking of inclusion of a reverse gear
      10.1.5. Removal, installation and adjustment of draft of gear shifting
      10.1.6. Replacement of sealing rings
      10.1.7. Check, removal and installation of the switch of lamps of a backing
      10.1.8. Removal and installation of a drive of a speedometer
      + 10.1.9. Transmission
   + 10.2. Automatic transmission
   + 10.3. Power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



10.1.4. Removal and installation of a cable of blocking of inclusion of a reverse gear

GENERAL INFORMATION

The mechanism of blocking prevents casual inclusion of a reverse gear. Blocking is released after a raising of the handle located under the handle of the lever of gear shifting. The top part of a cable is attached to the handle, and bottom is attached to blocking draft.

PERFORMANCE ORDER
1. At a rupture of a cable replace it as follows, but previously check that there are spare parts.
2. Remove the gear shifting lever.
3. Remove from the gear shifting lever the handle, previously its heating in hot water. Even at removal of the warm handle it can break.
4. Take a spring located under the handle.
5. Unscrew the screw from the top part of the lever of gear shifting.
6. Beat out the cylindrical pins, fixing the plastic coupling and the freshet lever to the basis of the lever of gear shifting. It is probable that at removal the plastic coupling will be damaged.
7. Remove a cable and a cable tip.
8. Installation is made in sequence, return to removal.