Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. Technical characteristics
   + 11.2. Pumping of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Forward brake shoes
   11.5. Replacement of back brake shoes on disk brakes
   11.6. Replacement of back brake shoes on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. Support of a forward brake
   + 11.11. Support of a back disk brake
   - 11.12. Back working brake cylinder
      11.12.1. Cylinder removal
      11.12.2. Cylinder repair
      11.12.3. Cylinder installation
   + 11.13. Main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of the hand brake
   11.19. Removal and installation of the lever of the hand brake
   11.20. Replacement of brake shoes of the hand brake on back disk brakes
   + 11.21. Anti-blocking system of brakes (ABS)
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



11.12. Back working brake cylinder

11.12.1. Cylinder removal

PERFORMANCE ORDER
1. At existence remove a wheel cap, then weaken bolts of fastening of a back wheel.
2. Lift a back part of the car and fix on supports.
3. Remove a back wheel.
4. Release the hand brake.
5. Unscrew the screw of fastening of a brake drum and remove a brake drum.
6. If the brake drum is kept by brake shoes, remove a cap from an opening in a brake board and, using a screw-driver, move a control lever of the hand brake to a brake shoe in order that brake shoes departed from a drum.
7. If necessary weaken a tension of a cable of the hand brake.
8. Note an arrangement and, using flat-nose pliers, remove the top returnable spring compressing brake shoes.
9. Remove the top ends of brake shoes from pistons of the working brake cylinder.
10. For reduction of losses of brake liquid uncover a popolnitelny tank of brake system.
11. Close a tank mouth polyethylene and again screw a cover. It is necessary in order that the cover tightly closed a popolnitelny tank.
11. Remove dirt round a place of connection of a brake tube to a back part of the working brake cylinder.
12. Unscrew a connecting nut.
13. Being careful, take a brake tube from the working brake cylinder and close it a stopper.
14. Unscrew two bolts of fastening of the working brake cylinder to a brake board and, being careful, remove the working brake cylinder.