Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. Technical characteristics
   + 11.2. Pumping of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Forward brake shoes
   11.5. Replacement of back brake shoes on disk brakes
   11.6. Replacement of back brake shoes on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. Support of a forward brake
   + 11.11. Support of a back disk brake
   + 11.12. Back working brake cylinder
   + 11.13. Main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of the hand brake
   11.19. Removal and installation of the lever of the hand brake
   11.20. Replacement of brake shoes of the hand brake on back disk brakes
   + 11.21. Anti-blocking system of brakes (ABS)
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



11.20. Replacement of brake shoes of the hand brake on back disk brakes

GENERAL INFORMATION

With back brake disks the hand brake works at models irrespective of hydraulic brake system. Brake shoes of drum-type type are thus used, and as a brake drum the internal part of a brake disk is used.

PERFORMANCE ORDER
1. Remove a back brake disk.
2. Disconnect a cable (it is specified by an arrow) hand brake and a returnable spring from a control lever of the hand brake on a brake board.
3. Using flat-nose pliers, remove plates of springs of fixing of brake shoes, pressing a plate and turning it on 90 °.
4. Remove springs and take a pin (it is specified by an arrow) clamp of a back brake shoe.
5. Remove brake shoes together with springs, a regulator and a razzhimny level. Remove springs and divide brake shoes.
6. Being careful and security measures, clear all traces of a brake dust from a brake drum, a brake board and blocks.
7. Apply a thin film high-temperature greasing on a regulator carving, then reduce length of a regulator to the minimum possible.
8. Apply a thin film high-temperature greasing on contact places (are specified by shooters) brake shoes with a brake board.
9. Collect blocks of the hand brake, a regulator and a razzhimny level, then connect brake shoes returnable springs.
10. Establish knot of blocks of the hand brake on a brake board, thus leading brake shoe establish on a clamp pin.
11. Establish a pin of a clamp of the second brake shoe, then establish springs and plates of a spring.
12. Establish a cable of the hand brake and a returnable spring on a control lever of the hand brake.
13. Establish a brake disk.
14. Adjust the hand brake.