Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. Technical characteristics
   + 11.2. Pumping of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Forward brake shoes
   11.5. Replacement of back brake shoes on disk brakes
   11.6. Replacement of back brake shoes on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. Support of a forward brake
   + 11.11. Support of a back disk brake
   + 11.12. Back working brake cylinder
   + 11.13. Main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of the hand brake
   11.19. Removal and installation of the lever of the hand brake
   11.20. Replacement of brake shoes of the hand brake on back disk brakes
   + 11.21. Anti-blocking system of brakes (ABS)
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



11.7. Check, removal and installation of a forward brake disk

Check

PERFORMANCE ORDER

Prevention

In need of replacement of a brake disk it is also necessary to replace and the second brake disk for ensuring uniformity of braking. At replacement of brake disks it is also necessary to replace brake shoes.


1. Tighten the hand brake, then lift a forward part of the car and fix on supports.
2. Remove the corresponding forward wheel.
3. Establish on two bolts of fastening of a wheel two washers in thickness of 10 mm and screw in fastening bolts in opposite openings.
4. Slowly turn a brake disk so that it could be considered from two parties. Wear of a brake disk from blocks should be in admissible limits. If there are cracks on a disk, the disk is subject to replacement.
5. Using a micrometer, measure thickness of a brake disk.
6. The indicator of hour type check palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a brake disk, define its palpation at distance of 10 mm from external edge.
7. Before check of palpation of a brake disk be convinced that the bearing of a nave is in a good condition.
8. Check a brake disk on existence of cracks, especially round openings under bolts of fastening of a wheel, and also on existence of wear or mechanical damages and, if necessary, replace it.

Removal and installation

PERFORMANCE ORDER
1. Remove brake shoes.
2. Unscrew the screw, a fixing brake disk to a nave and remove a brake disk.
3. If the brake disk sits densely on a nave, from a reverse side of a disk knock on it with a kiyanka.
4. Installation is made in sequence, return to removal taking into account the next moments.
5. Check and, if necessary, clear interfaced surfaces of a brake disk and a nave.
6. At installation of a new brake disk remove from its surface a sheeting layer.