Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. Technical characteristics
   + 11.2. Pumping of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Forward brake shoes
   11.5. Replacement of back brake shoes on disk brakes
   11.6. Replacement of back brake shoes on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. Support of a forward brake
   + 11.11. Support of a back disk brake
   + 11.12. Back working brake cylinder
   + 11.13. Main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of the hand brake
   11.19. Removal and installation of the lever of the hand brake
   11.20. Replacement of brake shoes of the hand brake on back disk brakes
   + 11.21. Anti-blocking system of brakes (ABS)
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



11.8. Check, removal and installation of a back brake disk

Check

See subsection 11.7.

Removal and installation

PERFORMANCE ORDER
1. Unscrew two bolts, fixing a support of a back brake.
2. Remove a brake support and, using a soft wire, tie up it to a back rack. Thus do not stretch and do not overwind a brake hose.
3. Release the hand brake, then remove a protective cap of a nave.
4. Take шплинт, fixing a nave nut from unscrewing. Unscrew a nut.
5. Remove brake a disk / nave from a fixing element of a nave.
6. If the brake disk does not act in film, through an opening in a brake board take away blocks of the hand brake from a drum of a brake disk.
7. Installation is made in sequence, return to removal taking into account the next moments.
8. At installation of a new brake disk remove from its surface a sheeting layer.
9. Adjust nave bearings / a brake disk.
10. Use new шплинт for fastening of a nut of a nave.
11. Adjust the hand brake.