Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. Suspension bracket and steering
   12.1. Technical characteristics
   + 12.2. Rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. Bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. Nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. Back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a being self-leveled back suspension bracket
   12.15. Removal and installation of a steering wheel
   + 12.16. Steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draft
   + 12.19. Steering transfer
   12.20. Air removal from steering system with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation of a popolnitelny tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. Body
+ 14. Electric circuits



12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Unscrew screws and remove the bottom casing of a steering column.
Contact group of the lock of ignition
3. Disconnect contact group from the ignition lock.
4. Unscrew two screws and take contact group of the case of the lock of ignition.
5. Installation is made in sequence, return to removal.
6. Check, that the central part of contact group was correctly combined with a rod of the cylinder of the lock.
Lock cylinder
7. Insert a key into the lock of ignition and turn it in situation II.
8. Using a steel core (it is specified by an arrow) in diameter of 3 mm, inserted through an opening in a casing of the lock of ignition, release a clamp and take the cylinder of the lock of ignition for the ignition key.
9. Before installation of the new cylinder of the lock of ignition insert the ignition key and turn it in situation II.
10. Insert the cylinder into a casing of the lock of ignition before its accurate fixing by a spring then take a key.
11. Connect a weight wire to the accumulator and check operation of the lock of ignition.
12. Establish the bottom casing of a steering column.