Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. Suspension bracket and steering
   12.1. Technical characteristics
   + 12.2. Rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. Bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. Nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. Back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a being self-leveled back suspension bracket
   12.15. Removal and installation of a steering wheel
   + 12.16. Steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draft
   + 12.19. Steering transfer
   12.20. Air removal from steering system with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation of a popolnitelny tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. Body
+ 14. Electric circuits



12.20. Air removal from steering system with the amplifier

GENERAL INFORMATION

Prevention

Air removal from system is necessary for making after a rassoyedineniye of hydraulic elements of system.


PERFORMANCE ORDER
1. Uncover a nutritious tank and check level of liquid which should be about max label on щупе for level measurement.
2. Start the engine on turns of idling and check that level of liquid is about max label on щупе. In the course of removal of air do not allow an exposure of a bottom of a popolnitelny tank.
3. Start the engine on turns of idling and from the center on 45 ° to the left and to the right several times turn a steering wheel, then turn two times a steering wheel from an emphasis against the stop. Do not leave a steering wheel in extreme situation, as in this case load of hydraulic system of the amplifier of a steering maximum.
4. Switch off the engine and check liquid level. If necessary add liquid.