Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. Suspension bracket and steering
   12.1. Technical characteristics
   + 12.2. Rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. Bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   - 12.7. Nave of a back wheel
      12.7.1. Removal and installation of a nave of a back wheel
      12.7.2. Replacement of bearings of a nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. Back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a being self-leveled back suspension bracket
   12.15. Removal and installation of a steering wheel
   + 12.16. Steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draft
   + 12.19. Steering transfer
   12.20. Air removal from steering system with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation of a popolnitelny tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. Body
+ 14. Electric circuits



12.7. Nave of a back wheel

12.7.1. Removal and installation of a nave of a back wheel

Removal

PERFORMANCE ORDER
1. Remove a brake disk / a brake drum.
Models till 1992
2. Using a screw-driver edge as the lever, remove a dustproof cap from a nave.
3. Take шплинт, fixing a nave nut from unscrewing, then unscrew a nut of fastening of a nave.
4. Remove from a nave pin a persistent washer and a nave.
Models since 1992
5. Disconnect the electric socket of the ABS sensor, then unscrew four nuts and remove nave knot together with a brake board.
6. As soon as there will be an access, disconnect a cable of the hand brake from the lever of a block of the hand brake.

Installation

PERFORMANCE ORDER
Models till 1992
1. Establish a nave and an internal ring of the external bearing on a nave pin. Thus do not damage the sealing ring established from the interior of a nave.
2. Establish a persistent washer and screw a nut of fastening of a nave, then adjust люфт the bearing of a back wheel.
3. Using new шплинт, fix a nut of fastening of a nave from unscrewing, then establish a dustproof cap of a nave.
4. Establish a brake disk / a brake drum.
Models since 1992
5. Check that interfaced surfaces of knot of a nave and a fixing element of a nave pure and dry, then establish nave knot on a fixing element of a nave and fix it nuts, having tightened them the demanded moment.
6. Connect the electric socket of the ABS sensor and establish a brake disk / a brake drum.