Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. Suspension bracket and steering
   12.1. Technical characteristics
   + 12.2. Rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. Bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. Nave of a back wheel
   12.8. Replacement of the back shock-absorber
   - 12.9. Back stabilizer of cross-section stability
      12.9.1. Removal and installation of the main stabilizer
      12.9.2. Removal and installation of the additional stabilizer
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a being self-leveled back suspension bracket
   12.15. Removal and installation of a steering wheel
   + 12.16. Steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draft
   + 12.19. Steering transfer
   12.20. Air removal from steering system with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation of a popolnitelny tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. Body
+ 14. Electric circuits



12.9. Back stabilizer of cross-section stability

12.9.1. Removal and installation of the main stabilizer

Removal

PERFORMANCE ORDER
1. Weaken bolts of fastening of one of back wheels, then lift a back part of the car and fix on supports.
2. Remove a back wheel.
3. Unscrew nuts and take bolts from two parties of the stabilizer of cross-section stability (the arrangement of nuts and bolts is specified by shooters).
4. Remove from a back part of the stabilizer the rubber shock-absorber.
5. Remove the back main stabilizer of cross-section stability towards the removed wheel.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. For simplification of installation of the rubber shock-absorber grease it with soap water.
3. Tighten bolts and nuts of fastening of the stabilizer the demanded moment.