Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
- 13. Body
   13.1. Technical characteristics
   13.2. Care of a body
   13.3. Repair of insignificant damages of a body
   13.4. Repair of strong damages of a body
   + 13.5. Cowl
   13.6. Removal and installation of forward furnish of the car
   13.7. Removal and installation of back furnish of the car
   13.8. Removal and installation of a forward wing
   13.9. Removal and installation of a fairing of a windscreen
   + 13.10. Doors
   13.11. Removal and installation of a trunk lid and торсионов
   13.12. Replacement of components of the lock of a trunk lid
   13.13. Windscreen
   13.14. Removal and installation of back being slightly opened glass
   13.15. Replacement of consolidation of back being slightly opened glass
   13.16. Replacement of an external rear-view mirror
   + 13.17. Seats
   13.18. Removal and installation of head restraints
   13.19. Removal of furnish of a luggage compartment
   13.20. Removal and installation of the central console
   13.21. Removal and installation of a ware box
   13.22. Replacement of seat belts
   13.23. Check and hatch service
   + 13.24. Electric equipment of a body
+ 14. Electric circuits



13.22. Replacement of seat belts

GENERAL INFORMATION

On forward seats inertial seat belts are established.

In non-working situation seat belts should be reeled up on inertial drums.

Seat belts which were exposed to strong loadings, it is necessary to replace.

PERFORMANCE ORDER
1. Cleaning of seat belts can be made only water with soap. Dry seat belts and only after that reel up them on inertial drums.
2. At replacement of a seat belt note an arrangement of washers (are specified by shooters) and laying and do not mix them at installation.
3. For access to the top fastening of a seat belt it is necessary to remove threshold furnish.
4. For removal of furnish of a rack of a door it is necessary to pull it inside and down.
5. For access to a back inertial drum of a seat belt remove back lateral furnish.
6. Separate the top fastening of a back seat belt.
7. For access to the bottom fastening of a back seat belt move a pillow of back sitting forward.