Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
- 13. Body
   13.1. Technical characteristics
   13.2. Care of a body
   13.3. Repair of insignificant damages of a body
   13.4. Repair of strong damages of a body
   - 13.5. Cowl
      13.5.1. Removal and cowl installation
      13.5.2. Removal and installation of a cable of the lock of a cowl
   13.6. Removal and installation of forward furnish of the car
   13.7. Removal and installation of back furnish of the car
   13.8. Removal and installation of a forward wing
   13.9. Removal and installation of a fairing of a windscreen
   + 13.10. Doors
   13.11. Removal and installation of a trunk lid and торсионов
   13.12. Replacement of components of the lock of a trunk lid
   13.13. Windscreen
   13.14. Removal and installation of back being slightly opened glass
   13.15. Replacement of consolidation of back being slightly opened glass
   13.16. Replacement of an external rear-view mirror
   + 13.17. Seats
   13.18. Removal and installation of head restraints
   13.19. Removal of furnish of a luggage compartment
   13.20. Removal and installation of the central console
   13.21. Removal and installation of a ware box
   13.22. Replacement of seat belts
   13.23. Check and hatch service
   + 13.24. Electric equipment of a body
+ 14. Electric circuits



13.5.1. Removal and cowl installation

PERFORMANCE ORDER
1. Open a cowl and enclose pure rags under cowl corners to protect a paint and varnish covering of the car at cowl removal.
2. In the presence of illumination of a motor compartment disconnect the electric socket from a bulb.
3. Using a marker, note position of hinges on a cowl.
4. Ask the assistant to support a cowl, then unscrew bolts of fastening of the left and right hinges of a cowl.
5. Being careful, remove a cowl.
6. If the new cowl is established, rearrange on it all demountable details.
7. Installation is made in sequence, return to removal.
8. If the probe of the lock of a cowl acted in film, adjust its length and tighten a lock-nut (1 – the probe, 2 – a washer, 3 – a spring, 4 – a lock-nut, X = 40–45 mm).
9. Close a cowl and check its arrangement of rather adjacent surfaces.
10. Adjust the provision of a cowl so that at the closed cowl the gap on perimeter of a cowl was identical from all directions.
11. For adjustment weaken bolts of fastening of hinges of a cowl and, moving a cowl, adjust its situation.
12. For adjustment of a forward part of a cowl on height it is necessary to screw in or unscrew rubber pillows.