Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
- 4. Engine
   - 4.1. The OHV engine (with a camshaft in the block of cylinders)
      4.1.1. Technical characteristics
      4.1.2. Compression check
      4.1.3. The repair operations which are not demanding removal of the engine
      + 4.1.4. The repair operations demanding removal of the engine
      4.1.5. Adjustment of gaps of valves
      + 4.1.6. Head of the block of cylinders
      4.1.7. Removal and installation of the oil pallet
      + 4.1.8. Oil pump
      + 4.1.9. Asterisks of the mechanism of a gazoraspredeleniye
      + 4.1.10. Pistons and rods
      4.1.11. Removal and flywheel installation
      4.1.12. Removal and installation of support of the power unit
      4.1.13. Removal and installation of a camshaft and pushers
      4.1.14. Removal and installation of a back sealing ring of a cranked shaft
      4.1.15. Removal and installation of a cranked shaft and radical bearings
      + 4.1.16. Check of elements of the engine
      4.1.17. System of greasing of the engine
      4.1.18. Removal and engine installation
      4.1.19. Engine start after major maintenance
   + 4.2. OHC engines
   + 4.3. The DOHC engine with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



4.1.14. Removal and installation of a back sealing ring of a cranked shaft

Removal

PERFORMANCE ORDER
1. Remove the engine from the car, then remove the oil pallet and a flywheel.
2. Weaken bolts of fastening of a back cover of a cranked shaft and take a back sealing ring of a cranked shaft.

Installation

PERFORMANCE ORDER
1. Grease working edges of a new sealing ring of a cranked shaft and, being careful, establish it into place so that it was aflush with a back cover of a cranked shaft.
2. Apply a thin film hermetic on interfaced surfaces of a back cover of a cranked shaft and tighten bolts of fastening of a cover the demanded moment.
3. Establish the oil pallet and a flywheel and then establish the engine in the car.