Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburetor
      6.1.1. Technical characteristics
      6.1.2. Use of unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and fuel level sensor installation
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management by an air zaslonka
      + 6.1.11. Carburetors
      6.1.12. Check of the electromagnetic valve of interruption of supply of fuel
      6.1.13. Removal and carburetor installation
      + 6.1.14. Carburetor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and installation of an exhaust system
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



6.1.13. Removal and carburetor installation

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove the air filter.
3. On hand-operated models of an air zaslonka disconnect from the carburetor a cable of management of an air zaslonka. On models with an automatic air zaslonka disconnect electric sockets and / or pipes of supply of cooling liquid. For reduction of losses of cooling liquid close the ends of pipes suitable jams.
4. Disconnect a hose of supply of fuel from a steam or carburetor separator. At existence disconnect a hose of return of fuel from the carburetor. Close the ends of hoses suitable jams.
5. Disconnect an accelerator cable.
6. Disconnect from the carburetor a vacuum hose of the distributor of ignition.
7. Disconnect the electric socket from the electromagnetic valve blocking supply of fuel.
8. Disconnect the remained hoses or wires, then unscrew nuts and remove the carburetor from hairpins. Remove carburetor laying.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal, taking into account the next moments.
2. In the presence of defects use new laying of the carburetor.
3. Adjust a cable of an accelerator and a cable of management of an air zaslonka.
4. If hoses of cooling liquid acted in film, check and, if necessary, finish to norm level of cooling liquid.
5. Adjust turns of idling and the contents WITH in exhaust gases.