Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburetor
      6.1.1. Technical characteristics
      6.1.2. Use of unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and fuel level sensor installation
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management by an air zaslonka
      + 6.1.11. Carburetors
      6.1.12. Check of the electromagnetic valve of interruption of supply of fuel
      6.1.13. Removal and carburetor installation
      + 6.1.14. Carburetor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and installation of an exhaust system
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



6.1.16. Removal and installation of a final collector

Removal

PERFORMANCE ORDER
Models of 1,2 l
1. Lift and fix on supports a forward part of the car.
2. Working under the car, disconnect from a final collector a reception exhaust pipe for what unscrew two bolts and remove springs.
3. Remove the air filter.
4. Unscrew six bolts, fixing a final collector to a head of the block of cylinders, and remove a collector and collector laying.
L models 1,3, 1,4 and 1,6
5. Remove the air filter. Remove an air inlet of the air warmed up by a final collector.
6. Unscrew nuts or bolts and disconnect from a final collector a reception exhaust pipe.
7. Unscrew nuts of fastening of a final collector and remove a collector from hairpins. Remove laying of a final collector.

Installation

PERFORMANCE ORDER
Models of 1,2 l
1. Installation is made in sequence, return to removal, but thus it is necessary to use new laying. A tightening of bolts of fastening of a collector make gradually and evenly, since the middle to edges.
L models 1,3, 1,4 and 1,6
2. Installation is made in sequence, return to removal, but thus it is necessary to use new laying. Tighten nuts of fastening of a collector gradually and consistently, beginning from the center to edge. At connection of a reception exhaust pipe to a final collector use new laying.