Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburetor
      6.1.1. Technical characteristics
      6.1.2. Use of unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and fuel level sensor installation
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management by an air zaslonka
      + 6.1.11. Carburetors
      6.1.12. Check of the electromagnetic valve of interruption of supply of fuel
      6.1.13. Removal and carburetor installation
      + 6.1.14. Carburetor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and installation of an exhaust system
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



6.1.18. Removal and installation of an exhaust system

GENERAL INFORMATION

Problem of an exhaust system is removal of the fulfilled gases in the atmosphere so that they even in the minimum quantity did not get to car salon, and also decrease in noise level of the engine. That the exhaust system could carry out the functions, it should be in good repair. The condition of an exhaust system influences also engine capacity and fuel consumption.

Removal

PERFORMANCE ORDER
1. For removal of an exhaust system lift a lobby or a back part of the car and fix on supports.
2. The exhaust system consists of three or four sections. Forward and back sections of an exhaust system can be removed independently from each other, but for removal of average section it is necessary to disconnect adjacent elements of fuel system. It is most convenient to remove an exhaust system assembled.
3. For removal of a lobby or back section of an exhaust system remove podpruzhinenny clips which connect sections of an exhaust system.
4. Remove the rubber pillows supporting section of an exhaust system, and at removal of forward section unscrew the bolts, fixing a reception exhaust pipe to a final collector.

Installation

PERFORMANCE ORDER
1. At connection of sections of an exhaust system use antiprigarny structure. Check a condition and, if necessary, replace clips, rubber pillows, consolidations and laying (in drawing – the graphite sealing ring established in elastic connection of sections of an exhaust system).
2. At installation of an exhaust system arrange it so that the weight of an exhaust system was evenly perceived by rubber pillows then tighten bolts of fastening of clips.