Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburetor
      6.1.1. Technical characteristics
      6.1.2. Use of unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and fuel level sensor installation
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management by an air zaslonka
      + 6.1.11. Carburetors
      6.1.12. Check of the electromagnetic valve of interruption of supply of fuel
      6.1.13. Removal and carburetor installation
      + 6.1.14. Carburetor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and installation of an exhaust system
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



6.1.5. Check, removal and installation of the fuel pump

Check

PERFORMANCE ORDER
1. Disconnect wires from primary winding of the coil of ignition.
2. Remove a hose from a target branch pipe of the fuel pump.
3. Wind a target branch pipe of the fuel pump with pure rags. The assistant should turn a cranked shaft a starter. Thus the entrance branch pipe should leave fuel strong, equal pushes. Lack of fuel testifies or to malfunction of the fuel pump, or about lack of fuel in a fuel tank.
4. If the fuel pump is faulty, it is necessary to replace it, as repair of the fuel pump is not provided.

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect fuel hoses (And – entrance, In – pressure head) from the fuel pump. If necessary mark hoses and close them suitable jams.
3. Unscrew nuts or bolts and remove the pump from the engine. Remove laying.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. At installation use new laying.
2. Start the engine and check fuel system on existence of leaks. In the presence of leaks immediately switch off the engine and eliminate leak. At installation of the fuel pump start of the engine can last more long than the usual.