Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburetor
      6.1.1. Technical characteristics
      6.1.2. Use of unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and fuel level sensor installation
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management by an air zaslonka
      + 6.1.11. Carburetors
      6.1.12. Check of the electromagnetic valve of interruption of supply of fuel
      6.1.13. Removal and carburetor installation
      + 6.1.14. Carburetor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and installation of an exhaust system
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and charging system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



6.1.8. Removal, installation and adjustment of a cable of an accelerator

Removal

PERFORMANCE ORDER
1. Remove the air filter.
2. Remove a spring bracket and disconnect the spherical hinge of a cable of an accelerator from the lever of a butterfly valve of the carburetor.
3. Remove a bracket, a fixing cover of a cable of an accelerator to an arm on the carburetor, then remove a sealing ring from an arm.
4. In salon of the car remove an accelerator cable from a pedal for what move back a spring and, using the lever, take an accelerator cable from the groove end.
5. Take a sealing ring of a cable of an accelerator from a partition of a motor compartment. Take an accelerator cable in a motor compartment of the car.

Installation

Installation is made in sequence, return to removal.

Adjustment

PERFORMANCE ORDER
1. Check that at completely pressed pedal of an accelerator the butterfly valve completely opens. Adjustment of a cable of an accelerator is made by shift of the bracket, fixing a cover of a cable of an accelerator to a carburetor arm. The bracket fixing a cover of a cable of an accelerator in an arm on the carburetor, is intended for adjustment of sagging of a cable of an accelerator.
2. On models of 1,3 l with the engine of 13 NB check that at completely drowned handle of management the small gap (it is specified by an arrow) between the screw of adjustment of the accelerated turns of idling and a plate of a cam of a zaslonka is available an air zaslonka.