Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
- 7. Start and charging system
   7.1. Technical characteristics
   7.2. Finding of malfunctions in electric chains
   + 7.3. Accumulator
   + 7.4. Generator
   + 7.5. Starter
   7.6. Replacement of the lock of ignition
   7.7. Removal and installation of the sensor of pressure of oil
   7.8. Removal and installation of the sensor of level of oil on models with 16 valves
   + 7.9. Electric equipment of diesel engines 16D, 16DA, 17D and 17DR
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



7.7. Removal and installation of the sensor of pressure of oil

GENERAL INFORMATION

The sensor of pressure of oil is screwed in in the block of cylinders or a fixing element of the oil filter.

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator and disconnect wires (are specified by shooters) from the sensor.
2. Unscrew the sensor and remove a sealing ring. If the sensor acts in film for a long time, close a suitable stopper an opening for the sensor.

Installation

PERFORMANCE ORDER
1. Check a condition of a sealing ring and, if necessary, replace it.
2. Screw in the sensor together with a sealing ring and tighten it the demanded moment. Connect to the sensor electric wires.
3. Check level of engine oil and, if necessary, finish it to norm.