Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
- 8. Ignition system
   - 8.1. Ignition system with the breaker
      8.1.1. Technical characteristics
      8.1.2. Check of system of ignition
      8.1.3. Adjustment of a gap and the closed condition of contacts of the breaker
      8.1.4. Removal and installation of contacts of the breaker
      8.1.5. Check, removal and condenser installation
      + 8.1.6. Ignition distributor
      - 8.1.7. Adjustment of a corner of an advancing of ignition
         8.1.7.1. The models using etilirovanny gasoline
         8.1.7.2. The models using unleaded gasoline
      8.1.8. Removal, check and installation of the coil of ignition
   + 8.2. Electronic contactless system of ignition
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



8.1.7. Adjustment of a corner of an advancing of ignition

8.1.7.1. The models using etilirovanny gasoline

GENERAL INFORMATION

For check and adjustment of a corner of an advancing of ignition it is necessary to use a stroboscope.

PERFORMANCE ORDER
1. Check a gap between contacts of the breaker or a corner of the closed condition of contacts of the breaker.
2. For adjustment of a corner of an advancing of ignition first of all clear adjusting labels on a pulley and a cover and mark out them white chalk or quick-drying paint.
3. Start the engine and warm up it to normal working temperature, then switch off.
4. Connect the stroboscope sensor to a high-voltage wire of the first cylinder according to the stroboscope maintenance instruction.
5. Start the engine on turns of idling and direct a stroboscope on adjusting labels. Labels will seem motionless and if a corner of an advancing of ignition correct, they are combined.
6. If labels are not combined, weaken fastening of the distributor of ignition and, turning it in the parties, combine labels then tighten a bolt of fastening of the distributor of ignition.
7. Increase engine turns, thus adjusting labels should move from each other.
8. Switch off the engine and disconnect a stroboscope.