Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
- 9. Coupling
   9.1. Technical characteristics
   - 9.2. Coupling cable
      9.2.1. Adjustment of a cable of coupling
      9.2.2. Removal and installation of a cable of coupling
   9.3. Removal and installation of a pedal of coupling
   + 9.4. Coupling
   9.5. Removal and installation of the vyzhimny bearing
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



9.2. Coupling cable

9.2.1. Adjustment of a cable of coupling

GENERAL INFORMATION

Prevention

In 1989 a part of cars were made with height of installation of a pedal of a brake on 15 mm above a coupling pedal. Normal installation of a pedal of a brake on 4 mm is lower than a coupling pedal. If necessary adjust height of installation of a pedal of a brake for what change length of a pusher of the vacuum amplifier of brakes, rotating a fork on a pusher.


PERFORMANCE ORDER
1. At replacement of coupling or a cable of coupling it is necessary to make initial adjustment of a cable of coupling.
2. Using a roulette, measure distance And from the center of a rubber overlay of a pedal of coupling to a steering wheel in a starting position of a pedal of coupling and write down the measured value.
3. Press a coupling pedal against the stop and carry out similar measurement (distance In).
4. Define a course of a pedal of coupling for what subtract the first measurement from the second. The course of a pedal of coupling should correspond to technical requirements.
5. Otherwise adjust length of a cable of coupling as follows.
6. In a motor compartment remove a bracket, fixing a carving tip of a cable of coupling to the squeezing lever and rotating a regulator, adjust a coupling cable. Regulator rotation clockwise increases a pedal course, and counter-clockwise – reduces it.
7. Make repeated measurement of a course of a pedal and establish a bracket fixing a carving tip of a cable of coupling.
8. If coupling is maintained a long time, probably, adjustment of a cable of coupling will not give result. It testifies to wear of frictional overlays of a disk of coupling and need of replacement of a disk of coupling.