Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
- 9. Coupling
   9.1. Technical characteristics
   + 9.2. Coupling cable
   9.3. Removal and installation of a pedal of coupling
   + 9.4. Coupling
   9.5. Removal and installation of the vyzhimny bearing
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



9.3. Removal and installation of a pedal of coupling

PERFORMANCE ORDER
1. In a motor compartment measure length of a carving tip of a cable of the coupling, acting of the squeezing lever. This size is necessary for using for ensuring the correct installation of a cable of coupling.
2. Remove a bracket, fixing a carving tip of a cable of coupling to the squeezing lever, and remove from the lever a carving tip. For simplification of removal move the lever to the engine.
3. In salon of the car remove the bottom panel of furnish in deepening for feet of the driver.
4. On the right side of an axis of a pedal of coupling remove fixing bracket, then unscrew a nut of fastening of a pedal and remove a washer.
5. Take an axis of a pedal of coupling from an arm, then lower down a pedal and a returnable spring.
6. Note an arrangement of washers and laying on an axis of a pedal of coupling for their repeated installation on the places.
7. Disconnect a coupling cable from a coupling pedal, release a returnable spring and take a pedal of coupling and a returnable spring from the car.
8. Installation is made in sequence, return to removal.
9. Before installation grease an axis of a pedal of coupling with greasing on the basis of a molybdenum disulfide.
10. If necessary adjust a coupling cable.