Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. Maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance
+ 4. Engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and charging system
+ 8. Ignition system
- 9. Coupling
   9.1. Technical characteristics
   + 9.2. Coupling cable
   9.3. Removal and installation of a pedal of coupling
   + 9.4. Coupling
   9.5. Removal and installation of the vyzhimny bearing
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Electric circuits



9.5. Removal and installation of the vyzhimny bearing

GENERAL INFORMATION

Prevention

At installation of the directing plug of the vyzhimny bearing it is necessary to use a new sealing ring.


PERFORMANCE ORDER
1. For access to the vyzhimny bearing it is necessary to remove coupling.
2. Unscrew a bolt, fixing a fork of switching off of coupling to an axis of the squeezing lever.
3. If the coupling cable is not disconnected from a transmission yet, remove the spring bracket, fixing a carving tip of a cable of coupling to the squeezing lever.
4. Remove a cable tip from the squeezing lever.
5. Remove vyzhimny the bearing from the directing plug.
6. Take from a coupling case an axis of the squeezing lever, thus an axis also should leave a fork of switching off of coupling.
7. At existence take vyzhimny the bearing from a plastic ring.
8. Check vyzhimny the bearing which should rotate easily, evenly and silently. The working surface of the bearing influencing a press spring, should be smooth, without cracks, local corrosion or development.
9. In the presence of defects replace vyzhimny the bearing.
10. At installation of new coupling vyzhimny it is also necessary to replace the bearing.
11. If necessary unscrew three bolts and remove directing plug of the vyzhimny bearing.
12. After removal of the directing plug of the vyzhimny bearing it is possible to replace a sealing ring of an entrance shaft of a transmission.
13. Remove the sealing ring established between the directing plug and a case of coupling.
14. Using screw-drivers as the lever, take a sealing ring from the directing plug.
15. Installation is made in sequence, return to removal taking into account the next moments.
16. Apply a thin film greasings on the basis of a molybdenum disulfide on an internal surface of plugs of an axis of the squeezing lever and an external surface of the directing plug of the vyzhimny bearing.
17. Using a tubular opravka of the corresponding diameter, establish a new sealing ring in directing plug.
18. Fill space between working edges of a sealing ring lithium greasing, then establish directing plug with a new sealing ring.
19. At installation of a sealing ring of the directing plug do not use greasing.
20. If necessary replace plastic plugs of an axis of the squeezing lever for what beat out them from a coupling case, using a drift and a hammer.
21. Establish new plugs in a case the couplings thus blocking uvulas of plugs should enter into the corresponding grooves in a coupling case.
22. At existence establish vyzhimny the bearing in a plastic ring, then establish vyzhimny the bearing together with a fork of switching off of coupling on directing plug.
23. Insert into a coupling case an axis of the squeezing lever and tighten a bolt of fastening of a fork of switching off of coupling.
24. Establish coupling.
25. Check and, if necessary adjust a coupling cable.